Keep the scanner inside the tent and place the overlay on top when the object is in place. Place the object (use the duck for your first scan) on the turntable to scan. If your scanner is always in the same space you can disable the calibration before next scanning. Note: Ensure the scanner is placed within the tent and the overlay is placed over the tent. Place the scanner in a stable place - vibrations can cause calibration and scan errors due to the use of high precision laser.Ĭalibrating will determine the distance to the turntable and prepare for the scanning process. You will then be instructed to remove everything from the turntable to calibrate the device. When the software opens, Click on the Scan button. Provide your email to register your SOL Scanner to receive new software releases and more. įollow the 7 steps below and use the duck as your scanning object first time to make sure it is set up right and you are ready to scan anything you like. Use the near scanner position for this scan. Your first scan should be a test scan of the duck that comes with your SOL 3D scanner. Run the installer and follow the instructions to install the software. Software installationĭownload the SOL Software for PC or MAC here. New to SOL 3D Scanner? Download the Quick start guide (more languages at bottom of page) to get up and running in no time and get some good tips on scanning - or follow the guide on this page.
0 Comments
Leave a Reply. |